MG96-M Series Non-Skid Paint is uniquely formulated with a Super-Tough Epoxy Binder to provide a durable, textured surface for safe foot traffic in wet conditions. Contains a synthetic grit with no sharp edges. Fast drying (48 hours), durable and easy to apply with a brush or roller. Aids in the reduction of slips and falls. NOT ABRASIVE TO BARE FEET Non-Skid Paint is perfect for metal surfaces such as Auto Haulers, Auto Lifts, Aluminum Ramps, Lift Gates, and Approach Plates. It is a product that will not harm the environment when used as directed. Colors: Shipstone Gray, Black, and Clear. Coverage (300 sq. ft. per Gallon) Two coats are required for proper application. Apply in temperatures between 60 to 90 degrees. MARINE GRADE: 1-Part (Water Base) Epoxy with Grit NON-SKID PAINT - Product Overview TEXTURED EPOXY COLOR COATING DESCRIPTION NON-SKID PAINT is a (one part) Water Based Epoxy with Grit textured color coating. Specifically designed to provide a slip resistant durable textured surface for firmer footing under wet and dry surface conditions. NON-SKID PAINT can be applied to magnesite decking, concrete, wood, fiberglass, steel and treated aluminum. COLORS IN STOCK CLEAR, WHITE, BLUE, BLACK, SHIPSTONE GRAY, CHAMIOS BEIGE, OSHA YELLOW, OSHA ORANGE SPECIAL ORDER COLORS BUTTERNUT, SEQUOIA GREEN, RUSSET RED, UMBER BROWN COLOR CHANGES It is recommended to use NON-SKID PAINT in (WHITE) to add too another color to achieve a lighter shade in that same color. For color consistency use a 2 to 1 ratio. Example: for every 2 gallons of chosen color NON-SKID PAINT add 1 gallon of (WHITE) NON-SKID PAINT. COVERAGE 300 SQUARE FEET PER GALLON @ 4 MILS WET = 1.5 MILS DRY (A two-coat application is recommended for most surfaces) CURING TIME – Temperature and Humidity Dependent DRYING TIME @ 77 DEGREES *F with 50% RELATIVE HUMIDITY (Avoid painting late in the day when condensation is likely or if rain is forecasted) TO THE TOUCH………………………………………30 – 40 Minutes TACK FREE RECOAT or TOPCOAT…………………………………………………2 – 3 HOURS DRY HARD………………………………………………………………….72 HOURS FULL CURE………………………………………………………………..5 – 7 DAYS CLEAN UP INFORMATION CLEAN HANDS AND TOOLS IMMEDIATELY WITH SOAP AND WARM WATER. HELPFUL TIPS DO NOT USE on garage floors or other areas where vehicles are parked OR on smooth glossy surfaces such as ceramic tile. DO NOT USE in areas where there is continuous standing water or where ponding and puddling occurs. These areas must be leveled prior to use of NON-SKID PAINT. ADA (AMERICAN DISABILITIES ACT) APPROVED NON-SKID PAINT MEETS ADA REQUIREMENTS FOR SLIP RESISTANCE The Federal Register of the ADA – Appendix. Sec. A4.51 – specifies a Static Coefficient of Friction rating of at least 0.05 for standard slip resistance (ranging up to a maximum requirement of 0.08 for inclined ramps. NON-SKID PAINT far exceeds those requirements in all testing (ranging from a low of 0.14 to a high of 0.781) Static Coefficient of Friction.

Your Name:
*Email Address:
Review:
Your Rating:	1 out of 5 2 out of 5 3 out of 5 4 out of 5 5 out of 5
Verification:	(Reload Image)
	*Your email address will not be shared with anyone.