Product Details
12 pack. Shipstone Grey, Black, or Safety Yellow choice of colors
Solvent Based, Only Ships UPS Ground.
Availability: | In Stock |
Ships From: | Dana Point, CA |
Full Description
The Most Versatile Safety Product Available. Sold by the 12 pack. See SKU: MP-MP1A29E-1/2CASE for a 6pack
This Non-Skid Paint is uniquely formulated with a Super-Tough Epoxy Binder to provide a durable, textured surface for safe foot traffic in wet conditions.
Contains a synthetic grit with no sharp edges. Please note, the grit in the spray paint, is smaller than the grit in quartz and gallons, so it does not have the rougher surface that the brush on paint has!
Fast drying (24 hours), durable, and easy to apply spray-on application.
Aids in the reduction of slips and falls.
Non-Skid Paint is perfect for metal surfaces such as Auto Haulers, Auto Lifts, Aluminum Ramps, Lift Gates, and Approach Plates. It is a product that will not harm the environment when used as directed. Coverage (20 sq. ft. per 12 oz. can) Two coats are required for proper application.
Non-Skid Paint is self-priming on Fiberglass, Gelcoat, Epoxy, Magnesite Decking, and Concrete surfaces. On wood substrates use a exterior oil base or latex wood primer. For metal surfaces apply an exterior metal primer over clean, dry metal. This will also provide additional rust prevention.
You need to clean the surface, before painting: For Gelcoat and Fiberglass use Acetone. For Non-Ferrous Metals and Aluminum use a Industrial Degreaser and aluminum acid-etch preperation. On Concrete use Trisodium Phosphate (TSP), use a firm bristle brush and rinse off thoroughly with clean water. Area must be completely dry before application. If necessary, use a heat source such as a large Hot Air Dryer. These products are available through most Hardware Stores.
Apply in temperatures between 50 to 90 degrees.
NOT ABRASIVE TO BARE FEET - Most Cost Effective Means for Small Area Non-Slip Projects!
Colors: Shipstone Gray, Black, Safety Yellow, and Clear (amber tone).
MARINE GRADE: (Solvent Base) Spray-On Epoxy with Grit!